Skip to content

How we choose products

Every pick on thisJOLT comes from the same process, built on the makers' own documents. Here it is, including what we don't do.

1. Official documents only

We read each product's page, spec table, user manual and warranty terms on the maker's own site, or its official US distributor's, and note the date we checked them. The only other sources are standards bodies and government agencies. Review sites, forums, retailer listings and videos are never evidence. If a figure can't be confirmed from an official source, we leave it out.

2. Engine ratings are quoted, never derived

The number that decides a jump starter is the engine size its maker rates it for. We give that rating in the maker's own words, with gas and diesel kept apart, because the two are rarely the same: NOCO rates its GB40 for gas engines up to 6.0 liters and diesel engines up to 3.0 liters.

An engine rating is the maker's statement about its own product. Nothing on a spec table lets anyone else work it out, so we don't try: not from amps, not from cylinder count, not from a similar model. If a maker states no rating for a fuel, the guide says exactly that, and we never write that a jump starter will start a particular vehicle.

3. The traps we check for

Headline numbers in this category mislead. These are the checks every product record goes through:

  • Peak amps are not cranking amps. Clore prints both for its JNC660: "1700 peak amps (425 cranking amps)". We give peak amps only for a figure the maker labels peak, and keep cranking, start-assist and rated-at figures under their own labels. We never compare figures that carry different labels, and we never rank jump starters by amps.
  • Cranking amps (CA) are not cold cranking amps (CCA). We never turn one into the other, and we never hold a jump starter's rating up against the CCA label on a car battery as proof of anything.
  • Battery capacity needs its basis. Watt-hours are given as the maker states them. A milliamp-hour figure is given with the voltage the maker states, or marked "voltage not stated", because a figure at cell voltage and a figure at pack voltage can't be compared. We never convert mAh to watt-hours, and capacity is never presented as starting power.
  • Duty cycles are quoted, never derived. A duty cycle says how long a compressor may run before it has to rest, and it only means something with its conditions attached, as in VIAIR's "33% @ 100 PSI" or NOCO's "5 min on time / 30 min off time". We copy it word for word. We never turn minutes into a percentage or drop the pressure, and we never call a unit continuous-duty unless the maker states 100% or a continuous run time.
  • Airflow comes with its unit and its test pressure, as in "CFM: 1.97 @ 0 PSI". Free flow at 0 PSI is not flow at tire pressure, so we never convert liters per minute to CFM and never compare figures quoted at different pressures. When a maker gives no pressure, we write "pressure not stated".
  • An inflator's maximum PSI is a ceiling. The pressure your tires need is on the vehicle's door-jamb sticker or in the owner's manual; it is not the maximum on the tire sidewall, and it is not the inflator's rating.
  • A charger's battery types and voltages are copied exactly from its spec table. Lithium (LiFePO4), 6V and 24V support count only when the maker names them for that model.
  • Engine-start amps on a plug-in charger are not a jump starter's peak amps. They are different figures for different machines, and our guides keep them apart.

4. When a maker's own pages disagree

It happens: a description lists more battery types than the spec table, or a product page and a chart give two airflow figures. We report both versions and say which page each came from, or we leave the claim out. We never pick the more generous one.

5. Safety listings and warnings, in the maker's words

  • A listing is written exactly as the maker states it, with its file or standard number. "UL Listed, File: E32074" and "Conforms to UL2743" are different statements, and we never upgrade "conforms to" into "listed". An IP code describes dust and water protection only; it is not a safety listing.
  • Protection features are listed by the maker's own names for them. We never call a product safe, and we never repeat a maker's safety slogan as our own claim.
  • Warnings about heat and swelling, hot hoses, hydrogen gas and crank and rest limits are quoted word for word, with the page or manual they come from.
  • We give no jump-starting, wiring or charging instructions. For connection order, crank time and rest time, follow the manual for your exact model and your vehicle's owner's manual.

6. What stays out

  • We never use star ratings, review counts, customer reviews or sales ranks, including the ones makers show on their own pages.
  • Model variants sold through a single retailer are left out. Records use the maker's own model number for the version on its US site.
  • No brand can pay to be included or to move up.

7. Dates you can trust

Models and stock change quickly in this category, so each guide is checked against the makers' pages before it is published and again at each refresh. A guide's Updated date changes only when its content changes, and each guide says when its specs were last checked.

What we don't claim

thisJOLT is a research publication. We haven't lab-tested the products we cover: nothing here has been bench-tested, timed or measured by us, and we never present spec-sheet research as test results. Every figure is the maker's and is written that way: "NOCO rates", "per VIAIR", "up to", "the maker states". We earn commissions on some purchases through our links, and they never decide a pick; see the affiliate disclosure.